11/21/2023 0 Comments Reolink client setup windowsIf the “Auto tracking” switch entity is enabled, and a object disappears from view OR stops moving for the “Auto track disappear time”/“Auto track stop time”, the camera goes back to its original position. When a Reolink doorbell is pressed the quick reply message from the “Auto quick reply message” select entity will be played after “Auto quick reply time” seconds, unless the “Auto quick reply message” is set to off. When the camera is not moved and no person/pet/vehicle is detected for the “Guard return time” in seconds, and the “Guard return” switch is ON, the camera will move back to the guard position. “Floodlight turn on brightness” controls the brightness of the floodlight when it is turned on internally by the camera (see “Floodlight mode” select entity) or when using the “Floodlight” light entity. Number entitiesĭepending on the supported features of the camera, number entities are added for: To use such an entity, you must enable the entity first. If an entity listed below has an asterisk (*) next to its name, it means it is disabled by default. Asterisk (*) next to entities listed in this documentation To ensure you have the best latency possible, refer to the Reducing latency of motion events section. Not all camera models generate ONVIF push events for all event types, some binary sensors might, therefore, only be polled.įor list of Reolink products that support ONVIF see the Reolink Support Site. The latency for receiving the events is the best for ONVIF push and the worst for fast polling, the fastest available method that is detected to work will be used, and slower methods will not be used.įor redundancy, these sensors are polled every 60 seconds together with the update of all other entities. These sensors receive events using 3 methods in order: ONVIF push, ONVIF long polling or fast polling (every 5 seconds). Binary sensorsĭepending on the supported features of the camera, binary sensors are added for: The Images stream provides a sequence of image snapshots giving very low latency at the cost of a very low frame rate this can be used when the RTMP/RTSP/FLV video stream has too much lag.ĭual lens cameras provide additional streams for the second lens. The Sub stream camera entity is enabled by default the other streams are disabled by default. This integration creates a few camera entities, one for each stream type with different resolutions: Main, Sub, Ext, Snapshots Main, and Snapshots Sub. Switch between RTSP, RTMP or FLV streaming protocol.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |